Rollover Car Wash Machine

CR300-F is the high-end model among rollover car wash equipment series, an intelligent control car washer with following advantages:

u Small power, waterproof, low failure rate, low noise, and long service life.
Intelligent unattended model
Water consumption about 70L/ car, saving water over 90% compared with labor car washing.
u Modular design, easy to install and maintain.
Safer with multiple protection for both people, vehicles and car wash equipment itself.
Easy to operate.
Qualified air drying system with wonderful effect, over 85%.

Products

Equipment Size

Technical Parameters

Machine Functions

Site Size & Car Wash Size

Site Size(mm):1100*400*3500

Car Wash Size(mm):5600*2600*2000

Technical Parameters

Technical data sheet	CR300-F
Voltage Supply Requirements	AC 380V 50HZ (three-phase-five-wire system)
Air Supply Requirements	Air compressor, air pressure between 0.36 0 0.9 Mpa
Water Supply Requirements	Water pipe diameter DN25, water flow ≥200L/min; bucket/cistern≥1 ton
Vehicle Types	Sedans, SUV, MVP ( less than 7 sets)
Foundation Requirements	Thickness of ground concrete should be more than 15cm and be flat(±5mm）
Wash Time	One reciprocating wash 2.25 min / common wash 4.5 min/ fine wash 5.5 min
Total Power	30KW
Water Consumption	70-120L/ car
Power Consumption	0.5-1 degree/ car
Chemical Consumption	70 -130 ml/ car

Machine Functions

Clean the car thoroughly

Foam spray
1 up-down electric top brush+2 long vertical brushes+ 2 short vertical brushes, 360° cleaning, no blind corner

5-brush cleaning
4 top blowers + 2 side blowers = Super Strong Air Drying

Air drying ( 6 sets of blowers)
Apply a layer of protecting coating on the car surface, making the car clean and shining

Water wax spraying
Can brush 400, 000 cars/ times

Imported automatic cleaning EVA foam rubber brush
Making the machine work more intelligently and precisely

Intelligent PLC control system